Technical Library | Support

Go to the table of contents Go to the previous page You are at the end of the document
Reinstalling RiskVision from a USB Drive : Step 3: Reinstall TRITON RiskVision from a USB drive
Step 3: Reinstall TRITON RiskVision from a USB drive
Recovery USB | TRITON RiskVision | 06-June-2016
You can attach a monitor and keyboard to the appliance, or access the appliance via the iDRAC, to complete this procedure.
 
* 
Warning 
When you boot from the RiskVision USB installer, everything on the appliance is deleted.
Back up any information on the appliance that you want to save, and make sure the backup files are stored on another machine.
1.
Insert the USB drive containing the TRITON RiskVision installer into an open USB slot on your V10000 G4 appliance.
2.
Power on or reboot the appliance.
3.
As the appliance is starting, press F11 to launch the BIOS Boot Manager.
It may take a minute or more for system to initialize and open the Boot Manager.
4.
In the Boot Manager, select One-shot BIOS Boot Menu.
5.
When a list of devices appears, select the [Hard drive] Disk connected to <USB slot>: <USB type> option and press Enter.
The appliance boot process continues, launching the RiskVision installer.
6.
In the installer menu, select RiskVision Installation for V10000 Appliance, then press Enter.
During the installation process, the system will restart automatically. It takes about 18 minutes for the entire installation to complete.
You will know the installation process has completed successfully when the appliance login prompt is displayed.
7.
Log in as root with the default password websense123, then immediately create a new password, as prompted.
8.
If DHCP is enabled in your network, the installation process automatically acquires an IP address for the C interface. If you are not using DHCP, or if you want to configure a specific IP address:
a.
Use the system-config-network command to update your eth0 configuration.
b.
Use the service network restart command to restart your network interfaces.
9.
Use the /opt/websense/rvadmin.sh restart command to restart all of the TRITON RiskVision services.
10.
Optionally also:
*
Set the system timezone using the timezone command.
*
Configure your keyboard or language settings with the system-config-keyboard and system-config-language commands.
Refer to the RiskVision Setup Guide (version 2.1 or version 2.0) for complete configuration instructions.

Go to the table of contents Go to the previous page You are at the end of the document
Reinstalling RiskVision from a USB Drive : Step 3: Reinstall TRITON RiskVision from a USB drive
Copyright 2016 Forcepoint LLC. All rights reserved.