Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Working With Log Files > Event log file formats > Choosing binary or ASCII
Choosing binary or ASCII
Help | Content Gateway | Version 8.1.x
You can configure Content Gateway to create event log files in either of the following:
*
ASCII: these files can be processed using standard, off-the-shelf log-analysis tools. However, Content Gateway must perform additional processing to create the files in ASCII, resulting in an increase in overhead. Also, ASCII files tend to be larger than the equivalent binary files. ASCII log files have a .log filename extension by default.
*
Binary: these files generate lower system overhead, as well as generally occupying less space on the disk, depending on the type of information being logged. You must, however, use a converter application before you can read or analyze these files using standard tools. Binary log files use a .blog filename extension by default.
While binary log files typically require less disk space, this is not always the case. For example, the value 0 (zero) requires only one byte to store in ASCII but requires four bytes when stored as a binary integer. If you define a custom format that logs IP addresses, a binary log file would require only four bytes of storage per 32-bit address. However, the same IP address stored in dot notation would require around 15 characters (bytes) in an ASCII log file.
For standard log formats, you select Binary or ASCII on the Configure > Subsystems > Logging > Formats tab in the Content Gateway manager. See Setting standard log file format options. For the custom log format, you specify ASCII or Binary mode in the LogObject. Refer to Custom format.
 
Note 
Before selecting ASCII versus binary for your log files, consider the type of data that will be logged. Try logging for one day using ASCII and then one day using binary. Assuming that the number of requests is roughly the same for both days, you can calculate a rough metric comparing the two formats.

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Working With Log Files > Event log file formats > Choosing binary or ASCII
Copyright 2016 Forcepoint LLC. All rights reserved.