Documentation | Support

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Integrating Forcepoint URL Filtering with Cisco > Configuring a Cisco IOS Router
Configuring a Cisco IOS Router
Deployment and Installation Center | Forcepoint URL Filtering
 
Applies to:                                         
*
Forcepoint URL Filtering, v8.5.x
After Forcepoint URL Filtering is installed, you must configure the Cisco IOS router to send HTTP requests to Filtering Service. This configuration is done through a console or telnet session. Filtering Service analyzes each request and tells the router whether to permit or block access, or to limit access with a time-limited control, as defined in web protection policies.
For instructions, see:
*
Cisco IOS startup configuration
*
Cisco IOS configuration commands
*
Cisco IOS executable commands

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Integrating Forcepoint URL Filtering with Cisco > Configuring a Cisco IOS Router
Copyright 2022 Forcepoint. All rights reserved.