Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Upgrading Email Security Gateway to v7.7 > Post-upgrade activities
Post-upgrade activities
Deployment and Installation Center | Email Security Solutions | Version 7.7.x
 
Applies to:                                                                                                          
*
Email Security Gateway and Email Security Gateway Anywhere v7.6.x
Your system should have the same configuration after the upgrade process as it did before the upgrade. Any configuration changes can be made after the upgrade process is finished.
After your upgrade is completed, redirect email traffic through your system to ensure that it performs as expected.
Email hybrid service registration information is retained during the upgrade process, so you do not need to complete the registration again. However, you must repair the registration with Data Security, as described in the next section.
Data Security registration
You must re-register Email Security Gateway with the Data Security module, using the following procedure:
1.
In the TRITON - Email Security module, navigate to Settings > General > Data Security and click Unregister.
2.
In the TRITON - Data Security module, navigate to Settings > Deployment > System Modules.
3.
Click the Email Security Gateway entry.
4.
Click Delete at the top of the System Modules > Email Security Gateway page to remove Email Security Gateway registration.
5.
When prompted, click Deploy to apply the changed Data Security setting.
6.
In the TRITON - Email Security module, navigate to Settings > General > Data Security.
7.
Register the Email Security appliance with Data Security.
8.
Return to the Data Security module and click Deploy in the upper right area of the screen.

Go to the table of contents Go to the previous page Go to the next page
Upgrading Email Security Gateway to v7.7 > Post-upgrade activities
Copyright 2016 Forcepoint LLC. All rights reserved.