![]() |
![]() |
![]() |
![]() |
![]() |
Troubleshooting > X10G Switch configuration and recovery > Switch recovery techniques > Configuring the switch mode
|
2. On any blade except blade 16, to configure switch A1: Run the CLI command "switch A1 configure" in Security Blade Manager. This configures switch A1 for use with all X10G blade servers.
3. On any blade except blade 16, to configure switch A2: Choose a mode for Switch A2 in the Security Blade Manager:
![]()
Run the CLI command "switch A2 configure wcg" to configure switch A2 to support failover for proxy interfaces on blade 16. (This disables the N interface, used if Network Agent runs on blade in Slot 16.)
![]()
Run "switch A2 configure na" to configure switch A2 with the N interface for Network Agent supported (default setting).
4. Wait for the switch to finish rebooting, then run "switch A1 (A2) verify" to verify that the configuration is as expected.
![]() |
![]() |
![]() |
![]() |
![]() |
Troubleshooting > X10G Switch configuration and recovery > Switch recovery techniques > Configuring the switch mode
|