![]() |
![]() |
![]() |
![]() |
![]() |
Setting Up Websense X10G Security Blades > Switch configuration essentials
|
Switch A1 arrives from the Websense factory with a default configuration that supports the C interface for all blades on the chassis. It also supports the A1.P1 and A1.P2 interfaces on the blades in slots 1 through 15. These interfaces are used for proxy traffic.
1. Use the CMC Web interface to select SLOT-16 and run firstboot on the blade in slot 16. Change the blade's mode to wcg.
3. Log on to the Security Blade Manager for the blade in slot 1. Run the CLI command "switch A2 configure wcg" to configure the A2 switch so that the N interface is disabled.
4. Wait for the switch to finish rebooting, then run "switch A2 verify" to verify that the configuration is as expected.
![]() |
![]() |
![]() |
![]() |
![]() |
Setting Up Websense X10G Security Blades > Switch configuration essentials
|