Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Integrating Web Security with Cisco > Configuring a Cisco IOS Router
Configuring a Cisco IOS Router
Deployment and Installation Center | Web Security Solutions | Version 7.8.x
Applies to:                                         
*
Web Filter and Web Security, v7.8.x
After Websense Web Filter or Web Security is installed, you must configure the Cisco IOS router to send HTTP requests to Websense software. This configuration is done through a console or telnet session. Websense software analyzes each request and tells the router whether or not to permit access or to limit access with quotas, defined in Websense filtering policies.
*
Cisco IOS startup configuration
*
Cisco IOS configuration commands
*
Cisco IOS executable commands

Go to the table of contents Go to the previous page Go to the next page
Integrating Web Security with Cisco > Configuring a Cisco IOS Router
Copyright 2016 Forcepoint LLC. All rights reserved.