Status messages

Non-standard configuration

This status indicates that the switch was configured by your Websense partner or Websense Technical Support professional in a special way, to accommodate your network.

Typically, no action is required. The switch can operate in a non-standard configuration when properly provisioned.

If you wish to return the switch to its standard configuration, use the CLI command: switch A1 (A2) configure.

If this does not resolve the issue, check the switch firmware version. Switch firmware version must be version 4.2.0.4.

If the issue persists, perform Booting the switch to Dell settings and then Configuring the switch mode.

For additional assistance, please contact your Websense Support professional.