Providing system information

Support

Go to the table of contents

Go to the previous page

Go to the next page

Go to the index

View or print as PDF

Getting Started > Providing system information

Providing system information

Help | Content Gateway | Version 7.7.3

If Content Gateway is the proxy integration for Websense Web security (Web Security Gateway or Web Security Gateway Anywhere), the Policy Server IP address and port was specified during installation.

To complete configuration of Policy Server and Filtering Service timeout conditions and action (permit or block traffic), perform the following:

1.	Go to the Configure > My Proxy > Subscription > Scanning tab. Notice the IP address and port of Filtering Service. This is the information that you entered when you installed TRITON – Web Security.


	Note The Scanning tab appears only if you have subscribed to Web Security Gateway or Web Security Gateway Anywhere.

2.	Review the Communication Timeout setting. This is the time, in milliseconds, that Content Gateway waits on communication with Policy Server or Filtering Service before timing out and triggering the Action for Communication Errors setting.

The default timeout value is 5000 (5 seconds). If you change the value, you must restart Content Gateway.

3.	In the Action for Communication Errors section, select to permit or block traffic if a communication timeout condition occurs. When a timeout occurs, Content Gateway applies the setting and regularly polls the services to detect their return to service.

4.	Click Apply.

Go to the table of contents

Go to the previous page

Go to the next page

Go to the index

View or print as PDF

Getting Started > Providing system information