Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Installing components via the Custom option > Installing Web Security components > Network Card Selection Screen
Network Card Selection Screen
Deployment and Installation Center | Web Security Solutions | Version 7.7.x
 
Applies to:
*
Web Filter, Web Security, Web Security Gateway, and Web Security Gateway Anywhere, v7.7.x
This screen appears if Network Agent is selected for installation, even if the machine only has one network interface card (NIC).
Select the NIC that Network Agent should use to communicate with other Web Security components, then click Next.
*
All enabled NICs with an IP address are listed.
*
On Linux, NICs without an IP address are also listed. Do not choose a NIC without an IP address.
After installation, you can configure Network Agent to use NICs without an IP address to monitor Internet requests. See Network Agent and stealth mode NICs.
 
* 
Note 
For Network Agent to operate, this machine must be connected to a bi-directional span port (or mirror port) on a switch or hub that processes the network traffic to be monitored.
You may select multiple NICs. After installation, use TRITON - Web Security to configure how Network Agent will use each selected NIC (for more information, see the TRITON - Web Security Help).

Go to the table of contents Go to the previous page Go to the next page
Installing components via the Custom option > Installing Web Security components > Network Card Selection Screen
Copyright 2016 Forcepoint LLC. All rights reserved.