Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Upgrading Data Security to v7.6.0 > Upgrading Data Security endpoints
Upgrading Data Security endpoints
Deployment and Installation Center | Data Security Solutions | Version 7.7.x
Applies to:                                         
*
Data Security, v7.1.x, 7.5.x, 7.6.x
First upgrade the Data Security Management Server and any supplemental Data Security servers. Then upgrade Data Security endpoints. Upgrade endpoints by deploying the 7.6 version of them to their current locations. See Deploying Websense endpoints.
 
* 
Important 
At the completion of any endpoint update, you must restart the endpoint for the updates to take effect.
It is possible that some endpoints are not connected to the network or are unavailable for upgrade for some other reason. These endpoints will continue to function and be able to identify breaches and create incidents. They will operate according to the last policy applied to it.
In version 7.6, you can configure prior-version endpoints to operate in monitoring mode until they are updated. In this mode, the endpoints only audit actions and do not block.
 
* 
Note 
A prior-version endpoint configured to block printscreen actions will continue to block that action even if you set it to monitoring mode in version 7.6.
Incidents from prior-version endpoints will continue to be accepted by upgraded Data Security Management and supplemental servers.
Data Security Management Server is upgraded to be part of the version 7.6 TRITON Unified Security Center. Note that during upgrade, if there are multiple network interfaces on the machine, you can choose a different IP address than that currently used. If you do so, endpoint clients configured to connect to endpoint servers on this machine will no longer be using the correct IP address. A solution to this situation is create a version 7.6 Data Security supplemental server using the old IP address so endpoint clients can still connect to it and (optionally) remove it after the endpoints have been updated to version 7.6 (connecting to the new IP address).

Go to the table of contents Go to the previous page Go to the next page
Upgrading Data Security to v7.6.0 > Upgrading Data Security endpoints
Copyright 2016 Forcepoint LLC. All rights reserved.