Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Integrating Web Security with Cisco > Configuring a Cisco Security Appliance
Configuring a Cisco Security Appliance
Deployment and Installation Center | Web Security Solutions | Version 7.7.x
 
Applies to:                                         
*
Web Filter and Web Security, v7.7.x
After Websense Web Filter or Web Security is installed, the Cisco security appliance, PIX firewall, or Adaptive Security Appliance (ASA) must be configured to work with Websense software. The Cisco firewall passes each Internet request to Filtering Service, which analyzes the request and determines whether to block or permit access, or limit access by using quotas set in Websense policies.
See the TRITON - Web Security Help for information about implementing filtering policies.
See the following for information about configuring Websense integration with Cisco PIX Firewall or Adaptive Security Appliance (ASA) through a console or Telnet session:
*
Cisco configuration command conventions
*
Cisco integration configuration procedure
*
User-based filtering for Cisco integration
For information on configuring your security appliance through the management interface, see the documentation for your Cisco product, available at www.cisco.com.
 
* 
Note 
In this topic, the term security appliance is used to refer to both Cisco PIX Firewall and ASA collectively.

Go to the table of contents Go to the previous page Go to the next page
Integrating Web Security with Cisco > Configuring a Cisco Security Appliance
Copyright 2016 Forcepoint LLC. All rights reserved.