Action and Syntax	Details
Display SNMP monitor server information. show snmp config
Enable or disable SNMP monitoring (polling). set snmp service --status <on|off>	SNMP monitor service and SNMP trap settings are independent, but SNMP monitor service must be enabled before you activate the SNMP trap configuration. Example: (config)# set snmp service --status on
Configure SNMP v1 monitoring. set snmp v1 --community <name>	Community name for the appliance. From 5 to 64 characters long with no spaces. All other ASCII characters can be used. Example: (config)# set snmp v1 --community testname
Configure SNMP v2c monitoring. set snmp v2c --community <name>	Community name for the appliance. From 5 to 64 characters long with no spaces. All other ASCII characters can be used. Example: (config)# set snmp v2c --community playground
Configure SNMP v3 monitoring. set snmp v3 --securitylevel <level> ...	There are 3 levels of security available for SNMP v3 monitoring: No authentication or encryption: noAuthNoPriv Authentication only: authNoPriv Authentication and encryption: authPriv See full syntax for each level, immediately below.
Configure SNMP v3 monitoring with no authentication or encryption. set snmp v3 --securitylevel noAuthNoPriv --user <username>	User specifies the account name to use for SNMP monitoring. Enter a user name between 1 and 15 characters long, with no spaces. Only alphanumeric characters can be used.
Configure SNMP v3 monitoring with authentication only. set snmp v3 --securitylevel authNoPriv --user <username> --authentication <md5|sha>	User is the account name to use for SNMP communication. Enter a user name between 1 and 15 characters long, with no spaces. Only alphanumeric characters can be used. SNMP authentication protocol (md5 or sha) specifies an interactive mode for entering the authentication password. Enter an authentication password between 8 and 64 characters long, with no spaces. All other ASCII characters can be used. Example password dialog: (config)# set snmp v3 --securitylevel authNoPriv --user test --authentication md5 Password: ******** Confirm password: ********
Configure SNMP v3 monitoring with authentication and encryption. set snmp v3 --securitylevel authPriv --user <username> --authentication <md5|sha> --encrypt <des|aes>	User is the account name to use for SNMP communication. Enter a name between 1 and 15 characters, with no spaces. Only alphanumeric characters can be used. SNMP authentication protocol (md5 or sha) specifies interactive mode for entering password. You are prompted for a password and encryption key. The 1 to 64 characters, and the key 8 to 64 characters long, with no spaces. All other ASCII characters can be used. Example: (config)# set snmp v3 --securitylevel authPriv --authentication sha --encrypt des --user test Password: ******** Confirm password: ******** Encrypt key: ******** Confirm encrypt key: ********