Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
V-Series Appliance Configuration > V-Series appliance network interface configuration > V-Series support for IPv6
V-Series support for IPv6
Help | V-Series Appliance | v8.2.x
Use the Configuration > Network Interfaces > IPv6 pages to configure IPv6 support on V-Series appliances that host a web protection solution.
*
TRITON AP-EMAIL does not include IPv6 support.
*
IPv6 support is disabled by default.
 
* 
Important 
After you enable it, disabling IPv6 support again requires a full restart of the appliance.
When you enable, then disable IPv6 support, any existing IPv6 values remain in the configuration files, but they cannot be edited.
For all web protection solutions, IPv6 support includes:
*
Dual IP stack configuration for interfaces C and N
*
IPv6 traffic to the Internet or clients on interfaces C and N, including block pages sent on C or N
*
IPv6 static routes
*
SNMP traps and counters for IPv6 data
*
Network diagnostic tools in the Command Line Utility and Command Line Interface
For TRITON AP-WEB, IPv6 support also includes:
*
Dual IP stack implementation on interfaces P1 and P2
*
Traffic to the Internet or clients on interfaces P1 and P2, and their bonded interface (E1/E2), if configured
Limits and restrictions:
*
IPv6-only internal networks are not supported
*
IPv4 must be used to communicate among V-Series appliances and with TRITON components
In any field that accepts an IPv6 address, the address can be entered in any format that conforms with the standard. For example:
*
Leading zeros within a 16-bit value may be omitted.
*
One group of consecutive zeros may be replaced with a double colon.

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
V-Series Appliance Configuration > V-Series appliance network interface configuration > V-Series support for IPv6
Copyright 2016 Forcepoint LLC. All rights reserved.
View all fonts in this project