Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
V-Series Appliance Configuration > V-Series appliance network interface configuration > Configuring V-Series TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2)
Configuring V-Series TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2)
Help | V-Series Appliance | v8.2.x
TRITON AP-EMAIL interfaces handle bidirectional email protection traffic.
 
* 
Note 
The names of the interfaces vary depending on the model of V-Series appliance.
*
With V10000, E1 and E2 are used.
*
With V5000, P1 and P2 are used.
*
Both the E1 and E2 interfaces (V10000) or P1 and P2 interfaces (V5000) can be used to accept inbound traffic and send outbound traffic.
*
In many deployments, E1 (or P1) is used for both inbound and outbound traffic; E2 (or P2) is not used.
*
E1 (or P1) can be configured to accept inbound traffic and E2 (or P2) can be configured to send outbound traffic.
When you need to support a large volume of outbound traffic, you can configure virtual interfaces on E1 or E2 (P1 or P2). See V-Series appliance Email module virtual interfaces.
 
* 
Important 
On the V10000, if you use the E2 interface, the E1 interface is bound to eth0, and the E2 interface is bound to eth1.
On the V5000, if you use the P2 interface, the P1 interface is bound to eth0, and the P2 interface is bound to eth1.
Keep this in mind when you configure TRITON AP-EMAIL.
Guidelines for configuring network interfaces E1 and E2
 
* 
Note 
On a V5000, substitute P1 for E1 and P2 for E2.
If you use both E1 and E2, and you locate them in the same subnet, then the default gateway is automatically assigned to E2 (which is bound to eth1). Ensure that outbound packets can reach the Internet.
 
IP address (E1 or E2 interface)
Required
Subnet mask
Required
Default gateway
Required
The gateway must be in the same subnet as the IP address of the interface (E1 or E2) used for communicating with the Internet (outbound traffic).
If you use both E1 and E2, and you locate them in the same subnet, then the default gateway is automatically assigned to E2 (which is bound to eth1). Ensure that outbound packets can reach the Internet.
Primary DNS
Required
IP address of the domain name server
Secondary DNS
Optional
Serves as a backup in case the primary DNS is unavailable
Tertiary DNS
Optional
Serves as a backup in case the primary and secondary DNSes are unavailable

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
V-Series Appliance Configuration > V-Series appliance network interface configuration > Configuring V-Series TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2)
Copyright 2016 Forcepoint LLC. All rights reserved.