Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
V-Series Appliance Configuration > V-Series appliance network interface configuration > Configuring V-Series TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2) > V-Series appliance Email module virtual interfaces
V-Series appliance Email module virtual interfaces
Help | V-Series Appliance | v8.1.x
* 
Note 
On a V5000, substitute P1 for E1 and P2 for E2.
Multiple virtual IP addresses can be configured on E1 or E2.
*
Virtual IP addresses are used for outbound traffic only.
*
Virtual IP addresses are bound to the specified physical interface.
*
Virtual IP addresses must be in the same subnet as the specified physical interface.
*
A maximum of 10 virtual IP addresses can be specified for each physical interface (E1 and E2).
Multiple virtual interfaces can be helpful to support multiple domains and/or a large volume of outbound traffic.
To add virtual IP addresses to E1 or E2:
1.
Go to Configure > Network Interfaces > Virtual Interfaces and click Add.
2.
Select E1 or E2. If E2 has not been configured, it is not offered.
3.
In the Virtual IP address field, enter one IPv4 address per line.
4.
Click Add Interfaces.
To remove virtual IP addresses:
1.
On the Configure > Network Interfaces > Virtual Interfaces page, select the check box to the left of the entries you want to remove and then click Delete.
2.
Confirm your action.

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
V-Series Appliance Configuration > V-Series appliance network interface configuration > Configuring V-Series TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2) > V-Series appliance Email module virtual interfaces
Copyright 2016 Forcepoint LLC. All rights reserved.