Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Configuration > Network interface configuration > TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2)
TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2)
Help | V-Series Appliance | Version 8.0.x
TRITON AP-EMAIL interfaces handle traffic in to and out of the TRITON AP-EMAIL module.
 
Note 
*
*
*
*
 
Important 
On the V10000, if you use the E2 interface, the E1 interface is bound to eth0, and the E2 interface is bound to eth1. Keep this in mind when you configure TRITON AP-EMAIL.
On the V5000, if you use the P2 interface, the P1 interface is bound to eth0, and the P2 interface is bound to eth1. Keep this in mind when you configure TRITON AP-EMAIL with the Email Hybrid module.
Guidelines for configuring network interfaces E1 and E2
 
Note 
If you use both E1 and E2, and you locate them in the same subnet, then the default gateway is automatically assigned to E2 (which is bound to eth1). Ensure that outbound packets can reach the Internet.
 

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Configuration > Network interface configuration > TRITON AP-EMAIL interfaces (E1 and E2, or P1 and P2)
Copyright 2016 Forcepoint LLC. All rights reserved.