Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Enabling system alerts
Administrator Help | Forcepoint Email Security | Version 8.5.x
Determine how alerts are distributed by using one or more of the following delivery methods:
*
*
Use the page Settings > Alerts > Enable Alerts to configure alert delivery methods.
Email alerts
Email alerts are distributed to specific individuals via a notification message.
Enable email alerts
1.
From the Security Manager, navigate to the page Settings > Alerts > Alert Events.
2.
Selection indicates to deliver alerts and notifications to administrators by email.
3.
*
Email address to use as the sender for email alerts.
*
Email address of the primary recipient of email alerts. Each address must be separated by a semicolon.
*
Email addresses for recipients of completed report notifications. Each address must be separated by a semicolon.
4.
Email alerts are enabled.
SNMP alerts
SNMP alert messages are delivered through an SNMP Trap system installed in your network.
The SNMP protocol does not support the use of FIPS 140-2 Level 1 certified cryptography. Use Email alerts if FIPS-certified cryptography is required.
Enable SNMP alerts
1.
From the Security Manager, navigate to the page Settings > Alerts > Alert Events.
2.
3.
*
Name of the trap community on your SNMP Trap system.
*
IP address or name of the SNMP Trap system.
*
Port number used by SNMP messages.
4.
Click Check Status.
A test message is sent to your SNMP server to verify that the specified port is open.
5.
SNMP alerts are enabled.

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
Copyright 2022 Forcepoint. All rights reserved.