Documentation | Support

Go to the table of contents Go to the previous page Go to the next page
Initial Configuration for All Security Modules > Forcepoint DLP initial configuration
Forcepoint DLP initial configuration
Deployment and Installation Center | Data Protection
 
Applies to:                                         
*
Forcepoint DLP, v8.5.x, v8.6.x, v8.7.x, v8.8.x, v8.9.x
 
* 
Note 
The Data Security module of the Security Manager may not be available immediately after installation. It takes a few minutes to initialize the system after it is first installed.
To complete your Forcepoint DLP installation, log on to the Data Security module of the Security Manager and click Deploy.
See the Forcepoint DLP Getting Started Guide for initial setup instructions for newly installed agents, modules, and components.
In addition, the Initial Setup section of the Forcepoint DLP Administrator Help has information about:
*
Defining general system settings
*
Connection to directory services
*
System alerts
*
Setting up notifications
*
Notifications when policy breaches occur
*
Configuring web attributes
*
Web DLP policies
*
Policies for particular websites
*
Policy owners
*
Configuring email policies
*
Creating a regulatory and compliance policy
*
Configuring system modules

Go to the table of contents Go to the previous page Go to the next page
Initial Configuration for All Security Modules > Forcepoint DLP initial configuration
Copyright 2023 Forcepoint. All rights reserved.