Documentation | Support

Go to the table of contents Go to the previous page Go to the next page
Integrating Forcepoint URL Filtering with Cisco > Configuring a Cisco IOS Router
Configuring a Cisco IOS Router
Deployment and Installation Center | Forcepoint URL Filtering
 
Applies to:                                         
*
Forcepoint URL Filtering, v8.5.x
After Forcepoint URL Filtering is installed, you must configure the Cisco IOS router to send HTTP requests to Filtering Service. This configuration is done through a console or telnet session. Filtering Service analyzes each request and tells the router whether to permit or block access, or to limit access with a time-limited control, as defined in web protection policies.
For instructions, see:
*
Cisco IOS startup configuration
*
Cisco IOS configuration commands
*
Cisco IOS executable commands

Go to the table of contents Go to the previous page Go to the next page
Integrating Forcepoint URL Filtering with Cisco > Configuring a Cisco IOS Router
Copyright 2023 Forcepoint. All rights reserved.