Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Setting Up TRITON Appliances
Setting Up TRITON Appliances
Deployment and Installation Center | Web and Email Protection Solutions | v8.3.x
Applies to:                                                                                                          
*
TRITON Appliances, v8.3.x
*
TRITON AP-WEB and Web Filter & Security, v8.3.x
*
TRITON AP-EMAIL, v8.3.x
A TRITON appliance is a component of a complete TRITON deployment.
Setting up a TRITON deployment consists of 5 core tasks:
1.
Deployment planning and preparation
2.
Appliance hardware setup and/or virtual appliance creation
3.
Initial configuration: the firstboot wizard
4.
Post-firstboot appliance configuration in the command line interface (CLI)
5.
Installation and configuration of off-appliance components
TRITON appliance setup is described in detail in the TRITON Appliances Getting Started.
TRITON V-Series and X-Series appliances come with a hardware Quick Start poster packaged in the shipping container. The 2-page poster explains how to set up the hardware and cable the appliance to your network. You can also access the posters online.
*
V5000 G3 poster
*
V5000 G4 poster
*
V10000 G3 poster
*
V10000 G4 poster
*
X10G poster
 
 
* 
Important 
Some older V10000 and V5000 appliances are not supported with versions of 8.0 and higher. See this knowledge base article: V-Series appliances supported with version 8.x.

Go to the table of contents Go to the previous page Go to the next page
Setting Up TRITON Appliances
Copyright 2016 Forcepoint LLC. All rights reserved.