Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Integrating Web Filter & Security with Cisco > Configuring a Cisco IOS Router
Configuring a Cisco IOS Router
Deployment and Installation Center | Web Filter & Security | v8.2.x
After Web Filter & Security is installed, you must configure the Cisco IOS router to send HTTP requests to Filtering Service. This configuration is done through a console or telnet session. Filtering Service analyzes each request and tells the router whether to permit or block access, or to limit access with a time-limited control, as defined in web protection policies.
For instructions, see:
*
Cisco IOS startup configuration
*
Cisco IOS configuration commands
*
Cisco IOS executable commands

Go to the table of contents Go to the previous page Go to the next page
Integrating Web Filter & Security with Cisco > Configuring a Cisco IOS Router
Copyright 2016 Forcepoint LLC. All rights reserved.