Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page
Installing components via the Custom option > Installing Web Security components > Multiple Network Interfaces Screen
Multiple Network Interfaces Screen
Deployment and Installation Center | Web Security Solutions | Version 7.7.x
 
Applies to:                                         
*
Web Filter, Web Security, Web Security Gateway, and Web Security Gateway Anywhere, v7.7.x
This screen appears if multiple network interface cards (NICs) are detected on this machine.
Select the IP address of the NIC that Web Security components should use for communication. This NIC will also be used to send block pages when a user requests filtered content.
 
* 
Important 
The installer cannot determine whether IP addresses are valid. It simply lists the currently configured address of each detected NIC. Be sure to verify that the IP address you select is valid in your network. An incorrect IP address will prevent Websense software on this machine from functioning properly.
You will specify later whether this NIC is also used by Network Agent to monitor Internet traffic and send protocol block messages.
 
* 
Note 
If the selected NIC will be used by Network Agent, it must support promiscuous mode.

Go to the table of contents Go to the previous page Go to the next page
Installing components via the Custom option > Installing Web Security components > Multiple Network Interfaces Screen
Copyright 2016 Forcepoint LLC. All rights reserved.