Technical Library | Support

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
v8.0.1 Release Notes for Websense X-Series Appliances
v8.0.1 Release Notes for
Websense X-Series Appliances
60202 | Release Notes | Websense X-Series Appliances | 3-June-2015
Use these Release Notes to learn about what's new and improved for Websense® X-Series™ Appliances in version 8.0.1.
*
New for v8.0.1 in X-Series appliances
*
Resolved and known issues for v8.0.1 X-Series appliances
See, also, these companion Release Notes:
*
v8.0.1 Release Notes for Websense Web Protection Solutions
*
v8.0.1 Release Notes for TRITON AP-EMAIL
For installation instructions, see v8.0.x Getting Started Guide and v8.0.x Quick Start poster.
The table lists the upgrade paths to version 8.0.1.
To upgrade from
To this version
Step One
Step Two
7.8.2, 7.8.3, 7.8.4
8.0.1
Upgrade the Appliance module (APP) to 8.0.0
Upgrade all modules to 8.0.1
8.0.0
8.0.1
Upgrade all modules to 8.0.1
 
See the v8.0.x X-Series Upgrade Guide. If you are upgrading from v7.8.x, please also read v8.0.0 Release Notes for Websense X-Series Appliances.
 
* 
Important 
If you are preparing to upgrade from v7.8.x or v8.0.0 and you have never enabled the "websense-ts" account on the blades, you must enable it one time (via the CLI). Then you may disable it. It need not be enabled during the patch process. In the CLI, use:
set account websense-ts --status <on|off>
See, also, these X-Series v8.0 supporting documents:
*
X10G Switch Configuration guide
*
Using the X-Series Command Line Interface (CLI)

Go to the table of contents Go to the previous page Go to the next page View or print as PDF
v8.0.1 Release Notes for Websense X-Series Appliances
Copyright 2016 Forcepoint LLC. All rights reserved.